Uncategorized

10 Cards | 1 Kit – SSS August 2019 Card Kit (Part 2 of 2)

Hey there,

Back today with part 2 of my Simon Says Stamp 10C1K using the new Party Like a Panda card kit. Soooo adorable! I loved working with the little panda images and cute punny sentiments. Here’s what I came up with for my final 5 cards:

Here are your close-ups:

6

Loved all the blues and greens in these papers. Here I combined this streamer pattern paper with some of the green check and added a stripe of after midnight for him to sit on. I’ve placed the bear directly on the card base and then popped up the balloons with some foam dots.

6 inside

I’ve added an additional stripe of that dark blue to the side to finish up my inside panel.

6 close

copics: B99, BG13, R27, YG25, Y35

7

This is my favorite card out of all 10, hands down. I wanted to create the idea of the bear floating through the air and love how this turned out. I’m working on a longer card base to allow more room to create that “sky” idea. I added some stripes to the background for a little more interest and then added my ballons directly to the card base and popped up the bear and balloons on individual wobblers so I could get as much movement as possible. Finally finished up with some stamped stars and Studio Katia crystal fusion sequins.

7 inside

For the inside, I’ve accented the sentiment with some more stars and one last turquoise stripe along the bottom.

7 close a7 close b

copics: BG13, RV66, Y35, YG25, R43

5

I couldn’t get enough of this rainbow paper, so I’m using it again. Keeping things simple though. I added the paper and then popped up the sentiments with some foam tape. The bear is glued directly on the card base and for a little something different I’ve popped up one of the presents to cover up the cake.

5 inside

More stars…I couldn’t get enough of those either.

5 close

copics: YG25, BG13, RV66

9

I kept wanting a bamboo image to go with these bears so I thought about what could mimic that and came up with some paper straws. I trimmed the straw to about 1-inch pieces and then cut them in half and used some scor tape to stick them onto my card front. It’s not perfect but I like the dimension and it gives off the idea I was going for.

9 inside

I wanted to pull in a little more orange from the hat on the front so I did that with some stamped confetti on the inside.

9 close

Prismacolors: 916, 1009, 912, 921, 905

10

Finishing up here with a shaker card. I used MFT’s blueprints 32 frame to create the window and filled it with a leftover SSS mix from a few card kits ago and some gold stars. I popped up the panda so he was just peeking over the frame and finished him off with a party hat.

10 inside

I continued the same red paper from the frame on the front to finish off my inside panel with a couple stripes.

10 close

copics: Y35, R27

Thanks so much for stopping by to check out my cards. Hope I was able to give you some ideas to use with your kit. xoxo, Sarah

2 thoughts on “10 Cards | 1 Kit – SSS August 2019 Card Kit (Part 2 of 2)

  1. I love all of these. I love that you also show the insides. So glad that I bought this kit and found so many great ways to stamp it.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.